Best Upgrades for a KSC Glock?

[grimreefer]

I am pretty much a virgin to GBB gunsmithing. What are some of the most worthwhile upgrades?

I'm not so much looking to upgrade FPS. But accuracy and feel are important. Tightbore is pretty much a given I'd imagine. I've already got an enhanced recoil spring, but honestly I can't tell the difference between that and the stock one.

Is there anything to do that would minimize the effects of cool-down?

edit: sorry it is actually a KWA Glock, so it has a stock metal slide.

[surebet]

Depending on the model, a metal slide is an obvious choice. A Glock 18c is a tad more tricky to assemble back though.

High flow valves are good also, more blowback.

Tightbore is a step in the right direction.

Search the forums for the electric tape mode from Stalker, basically tightens the seal around the outer barrel and the slide.

[MikeMcNair]

most glocks have the same ammt of upgrades available, so feel free to follow along on my build... http://www.airsoftcanada.com/showthread.php?t=82506

[MikeMcNair]

Originally Posted by surebet

Search the forums for the electric tape mode from Stalker, basically tightens the seal around the outer barrel and the slide.

i tried to find this with no luck. any links perhaps?

[AngelusNex]

Tightbore is all you need, KSC/KWA glocks are amazing.

[MikeMcNair]

oh, ok. i am running a PDI 6.01 so i should be set. thanks!

[Gerkraz]

Get a new valve for your mags. The KSC/KWA Glock valves are the same as the USP valves and they are known to be weak. I have already had to replace 2 of 3...

[Tex]

Originally Posted by MikeMcNair

i tried to find this with no luck. any links perhaps?

what stalker did to his Glock 19 was replace the o-ring at the end of the barrel with tape so it fits into the outer barrel better. with just the o-ring it wobbles maybe 1mm side to side. using a bigger o-ring will do the same job.

[MikeMcNair]

gotcha! thanks. the PDI tight bore has two spots for O Rings, so i think that helps.