Airsoft Canada - View Single Post

Jam1984 · May 6th, 2009, 14:55

So, I've had a KWA glock for a number of years now. recently it started to display some problems and finally has given up the ghost of life.

At first, it seemed the slide was not returning correctly. Upon pulling the trigger the slide would go back, before getting stuck about just before it pushes the bb into the chamber.

I thought this might be the recoil spring, so i purchased a new guarder one which fixed the problem. only to create another one !

Insert loaded mag (with green gas) when i pull the trigger the slide racks as usual. the round goes firing off into the distance, but the trigger isnt returning to the ready position. ie, cock gun, pull trigger, round goes flying off, slide goes back and forth. Trigger stays locked back. Pulling the slide back again *frees* the trigger.

From looking at the hammer assembly, it appears undamaged. Well lubed, but not too much lube.

I've always run the gun on green gas without any problems, it does this with all the mags ( of which i have 4) I've warmed the mag to room temp and still the same result.

Any help is appreciated !

Cheers
Ben

May 6th, 2009, 14:55	#1
Jam1984 Trader rating Join Date: May 2009	KWA Glock 19, Trigger/Hammer problems So, I've had a KWA glock for a number of years now. recently it started to display some problems and finally has given up the ghost of life. At first, it seemed the slide was not returning correctly. Upon pulling the trigger the slide would go back, before getting stuck about just before it pushes the bb into the chamber. I thought this might be the recoil spring, so i purchased a new guarder one which fixed the problem. only to create another one ! Insert loaded mag (with green gas) when i pull the trigger the slide racks as usual. the round goes firing off into the distance, but the trigger isnt returning to the ready position. ie, cock gun, pull trigger, round goes flying off, slide goes back and forth. Trigger stays locked back. Pulling the slide back again frees the trigger. From looking at the hammer assembly, it appears undamaged. Well lubed, but not too much lube. I've always run the gun on green gas without any problems, it does this with all the mags ( of which i have 4) I've warmed the mag to room temp and still the same result. Any help is appreciated ! Cheers Ben