View Single Post
Old November 21st, 2008, 12:45   #29
Donster
 
Donster's Avatar
 
Join Date: Jul 2007
Location: GTA
Quote:
Originally Posted by []D[][]\/[][]D View Post
So here's my new revised upgrade parts list:

A.R.S. Sorbothane Cylinder Head Pad
Prometheus 6.03 EG Inner Barrel (455mm) covered up with a TM Knight's Pro Silencer
Prometheus EG Spring Guide with Bearing
Prometheus Hard Piston
Prometheus Non-Liner Spring (MS110)
Systema Air Seal Nozzle
Systema Anti-Reversal Latch
Systema Helical Gear Set 1 (High Speed)
Systema High Speed Metal Bushing with Bearing
Systema N-B Cylinder Type 1
Systema Silent Head Set
Systema Turbo Motor (Medium Type)


Now, what kind of battery should I get? An Intellect 9.6V 1400mAh Mini Battery or a FireFox 11.1V 1600mAh Li-Po Mini Battery?
i dont think your systema anti reversal latch, gears etc are necessary. Run stock gears, Prometheus airnozzel is great. if its cheaper, get that, if not, stick with the systema. dont replace the motor. Honestly, to simplify this, just get a Guarder cylinder set and pick up a sorbo pad. you will be fine then. if you want a little bit better quality, than get the following. i just picked up the following for my TM M14. I have done a lot of research, be it searching on the net/ASC, or talking with gundocs. with the following parts, i have concluded that you honestly cant do any wrong, so long as you get a gundoc to install them. hope this helps

Prometheus or Guarder Spring (100-110)
Prometheus Air nozzle (i have heard good things of this, especially in the TM M14)
Prometheus Hard Piston
ARS Cylinder Head
ARS Sorbo pad
Prometheus Spring guide

NOTE: for ARS products, contact Tirador. you can find his thread in my link in my sig.

That will give you power and not put too much stress on your internals. Other than that, you dont need anything else. Your gun will shoot hard, and last long and best of all, it shouldn't cost you that much.
Donster is offline   Reply With Quote