Airsoft Canada - View Single Post - problem : Hi capa with upgraded slide and frame

ichimaru gin · November 9th, 2008, 02:20

Thanks for the replies guys, your comments really help me out.

Sir racing maniac, yes I spotted that the trigger is easier to pull when I press on the top and middle rather than the bottom. If I glue the trigger to the trigger bar, will I still be able to replace the trigger in the future? or do you recommend this AFTER I buy a new trigger (Because I am planning to buy a PDI metal trigger)

Sir m10204, Can I use sanding paper instead of honing stone? IF I dont want to do anything you suggested and leave the blowback housing "untightened" is it OK?
I'm afraid that High gas usage is caused by this.

November 9th, 2008, 02:20	#6
ichimaru gin Trader rating Join Date: Sep 2008	Thanks for the replies guys, your comments really help me out. Sir racing maniac, yes I spotted that the trigger is easier to pull when I press on the top and middle rather than the bottom. If I glue the trigger to the trigger bar, will I still be able to replace the trigger in the future? or do you recommend this AFTER I buy a new trigger (Because I am planning to buy a PDI metal trigger) Sir m10204, Can I use sanding paper instead of honing stone? IF I dont want to do anything you suggested and leave the blowback housing "untightened" is it OK? I'm afraid that High gas usage is caused by this. Last edited by ichimaru gin; November 9th, 2008 at 02:29..