Quote:
Originally Posted by safx
No dude, those milled lines on the front of
the slide and frame are "over milled" on the
real and the replica. Wouldn't you want the
lower edge of the rail free from those tiny
nicks where the tool just went a little too far?
It would be different if the lines extended in
an obvious way through the frame instead
of stopping with little gouges. They look like
a mistake, and probably are.
|
I don't see how replicating the real steel can be wrong or bad.
Also, the slide wouldn't be cut while it's on the frame, that's silly. It was therefore obviously done on purpose.