|
I just got my G&G scar a week or so ago and i got my flash-hider off. It was a pain but not that hard. Just remove the barrel by taking off the lower rail via the two screws, then remove the two grub screws holding the barrel in and then slide the barrel out, its a tight fit so you might have to work it a little but its fairly easy...once it is out place the end that was inside the receiver into a towel and twist the barrel so that it grabs the fabric and is wound up tight in the towel (make sure you wind it the right way so it doesnt unwind when you start to twist the flash-hider), this makes it super easy to hold while applying pressure to the other end. Then either pad the flash hider with something and latch on with some vice grips or stick a screw driver through the openings in the hider and twist that sucker as hard as you can (remember its a counterclockwise thread so you have to twist clockwise when looking down the muzzel), i started with the vice grips but the ones i had were too small so i switched to the screwdriver. It takes alot of force, but amazingly i did not damage my flash-hider.
|