Quote:
Originally Posted by Amos
All gears should fit all bearings...
You shouldn't be using TM gears in a high-speed set up... You should look at a set of guarder, or Systema Helical High-speed (The systema would probably be your best bet, but I've never made a high-speed set up; so I don't have first-hand experience.)
|
I ruined a set off Systema bearings with TM gears. They are not compatible. But I would like to know what brand others have put them in. I understand TM gears are not designed for upgraded gun but I don't want to tear up Promy gears due to a lack of knowledge. I knew this would be trial and error since their is no clear-cut concept to reliable high speed setups. You just diagnose the issue and react.
Quote:
Originally Posted by Nova316
Did u take out the top part of the gearbox (Cylinder/piston/spring/tapplet plate... those) Then put in 2-3 screws into the gearbox, stick your finger into cylinder hole and try spinning the gears? they should spin very freely.. yet have no side to side play.
If u want to get highspeed i dont think theres much difference in bearings
|
Bearing would make a difference, they cause much less resistance than bushings and I do intend on getting a MB with bearings but I wasn't ready at the moment. The difference can be 2-3 RPS. And, yes! I took out my compression assembly to spin the gears while I was shimming. How else would you shim?
Need help! And does anyone know if TM gears will fit in King Arms bearings?