|
Ok, so here it is. (I had it done a few days ago but took me a while to wrestle up a camera). First thing I did was dismantle the magazine, pretty much as much as it can be. this is necessary as the screws that attach the dummy rds are on the bottom of the spring channel. Then I reattached the bottom of the mag. I then took 6in of clear ruler and drilled holes where the screws that hold the dummy rds in would go. I then took two pieces of thin plastic (about 1.5mm) and glued them to the underside of the ruler so that they were over the spring channel (yes they are necessary, otherwise the bbs start to try to double stack and the ruler wont stay in place.) Superglue was then put in the holes for the screws, this is required as the screws are meant to screw in to the dummy rds and hole in the channel piece is unthreaded. I then screwed the ruler in place. Then I placed another piece of plastic down the middle so that the ruler would be pushed against the channel guide be the top of the magazine (possibly unnecessary but I wanted the extra strength). I then reassembled the mag. Pics can be seen below. They are a little dark but it is possible to see the bbs in the mag when assembled.
|