Quote:
Originally Posted by pestobanana
You probably have the spring in there incorrectly. Just make sure the spring is pushing the latch toward the catches on the bevel gear. Make sure the spring has a hook on one side for the latch and is straight on the other to push against the mechbox.
|
I'll check that after doing the simpler things since it takes 4 hands to reassemble this bad boy, and I have a proper spring/sorbo on the way so I'll need to take apart then.
In the meantime, more searching and I'll reinstall/change the OE barrel and hopup assembly...
Quote:
http://www.airsoftcanada.com/showpos...15&postcount=4
Double feeding is generally associated with the barrel/hop up unit mating. If the barrel retainer clip is cracked, the barrel can slip forward a bit, allowing two BBs to enter instead of one.
...
also it is possible that the hop rubber's mouth (where the BBs been fed) was worn out which creates a double feeding. that hop rubber mouth serves as a stopper for the BB to feed one at a time during full-auto mode. if this is the case, you will have to change your hop rubber.
|