Time to upgrade to a M9, insurgency styleeeeeeeeeeee,
vat about dis
http://shop.ehobbyasia.com/nine-ball...l#.VMlDHE3QcyQ
http://shop.ehobbyasia.com/guarder-v...l#.VMlD2k3QcyR
You could go full Insurgency night ops style and get a silencer and extend your inner barrel to a super duper long secondary and put a super dupe cool 4x scope on your p226 for indoor sniping pew pew.
Edit:
Did some quick g00gling and from 2008...
Quote:
Posted 05 May 2008 - 11:34 AM
Do NOT run the Guarder 150% hammer spring or recoil spring, do NOT.
I have seen entire hammer mechanisms destroyed. On my guns I run 150% Proud recoil springs (RCC 130% are better) with stock hammer springs and mine shoot 340+.
The PDI barrel will break 320 fps. Another good mod is the SD CNC Valve Knocker but it requires a bit more experience to fit effectively.
I like this for a decent, good shooting, TM P226 with a plastic body:
PDI 6.01mm Tight Bore (97mm, if you run a threaded outer barrel you can usually hid a 112mm)
Nine Ball Air Seal
Nine Ball Dyna Piston
SD Valve Knocker
And that is it. The power is in the tight bore. The Dyna increases over all efficiency, and the SD Valve Knocker is a durability upgrade.
|