|
omg why would you want to replace those smexy bushings ._.
you can just get a punch and knock them out with a hammer.. a tap should pop it right out.
I use a screw driver bit extension to pop bushings out. The more flat surface area the better against the bushing if you want to keep them to reuse.
Knock them towards the inside of the gearbox... take the half of the gearbox and put it on a flat surface.. of find the most flat surface you can find across the sides of the shell and tap the bushings out. I use a 2x4 to put the gearbox on.
Depending how tight the holes are you could just press them in with any flat surface, the tool is unnecessary.
__________________
I futz with V2s, V3s and V6s. I could be wrong... but probably, most likely not, as far as I know.
|