Airsoft Canada - View Single Post

rfo8 · September 2nd, 2013, 22:04

Hello all,

I'm trying to replace the outer barrel and DD 10" Lite Rail that came stock with my Marui Recce EBB, in favor of a dytac stainless barrel and 12" rail system (ala true SEAL Recces).

In any event, I've removed the 6 retaining screws that suspend the free float DD rail from the delta rings and nada - I tug on the rail system and it doesn't budge.

I've gone as far as to remove the gas block and piston (both of which have no function but are just eye candy) in the hope that Marui may have hidden some retaining pin or something in there and it still won't move. I even tried to wedge a butter knife in between the DD rail and delta ring and even that won't pry it out.

I've looked down the inner rail and there doesn't seem to be anything else holding it in place, other than the remote possibility that the folks at TM soldered the rail on to prevent any and all wobble... but they wouldn't really do that, would they?

Has anyone here successfully removed the DD ralls from their Marui Recce and if so, hope did you do it?

September 2nd, 2013, 22:04	#1
rfo8 Trader rating Join Date: Sep 2013	Marui Recce DD Rail Removal Woes Hello all, I'm trying to replace the outer barrel and DD 10" Lite Rail that came stock with my Marui Recce EBB, in favor of a dytac stainless barrel and 12" rail system (ala true SEAL Recces). In any event, I've removed the 6 retaining screws that suspend the free float DD rail from the delta rings and nada - I tug on the rail system and it doesn't budge. I've gone as far as to remove the gas block and piston (both of which have no function but are just eye candy) in the hope that Marui may have hidden some retaining pin or something in there and it still won't move. I even tried to wedge a butter knife in between the DD rail and delta ring and even that won't pry it out. I've looked down the inner rail and there doesn't seem to be anything else holding it in place, other than the remote possibility that the folks at TM soldered the rail on to prevent any and all wobble... but they wouldn't really do that, would they? Has anyone here successfully removed the DD ralls from their Marui Recce and if so, hope did you do it?