|
I finally got my guarder parts in the mail!
First off, I tested my new we magazine. I noticed at the top of the magazine, the rubbery part is completely flat, unlike my mags that have the top rounded. I expect this is wear from the nozzle.
My can of propane is running out, but on one of my old mags, I could get 4 shots with the first locking back and 4 with the new mag but the first two lock back.
Next I got to installing the new mag catch. It was really hard because of the mag spring, but I got it installed and I took off the tape off the top of the bbu. Immediately I got 7 rounds per mag with MUCH more kick. SO that solved my problem, you are a genius (or have a super amount of experience lol).
I also have 4 o rings on my recoil spring that are like shims for the spring. Does this increase the power of the spring or just make it compressed a little earlier? In theory, If the spring gets 100% compressed with a slide cycle, the power of the spring should not increase because the o rings have just shifted its placement.
Anyways, with all of this, the slide does not really stick anymore. The slide pretty much makes a complete return to rest position, maybe about 1 -2 mm back.
Next I plan on disassembling my lower receiver to install the trigger bar. Is there a step by step instruction guide anywhere online? Are there any pieces that are very troublesome to look out for?
I want to replace the sights on my glock with nights sights, have you tried the big dragon?
|