|
Hey all,
I just got an LCT Main Spring Housing from WGC (they have a discount right now) and from what I've read the LCT stuff is similar or the same as the NOVA products.
The LCT MSH uses a pin to lock the hammer spring assembly (the spring and the block that goes on top of it) in place but I can't seem to fit mine into the hole; the dimensions seem to be way too tight for me to fit the pin through. Any way to try to fix this issue other than trying to ram the pin into the MSH? I have to hold down my Guarder 150% hammer spring as well so its a PITA to do so.
Also, the grub screw that holds the lanyard loop can be taken away easily and the lanyard loop can maybe be pulled 1-2mm out of the MSH but I can't seem to take the whole lanyard loop out. Is there anything else locking the lanyard loop in place (therefore I've missed something when trying to pull the loop out)? If not, besides trying to pull it out harder with tools is there anything else I can try to remove the loop (I've tried running a burlap string through it and pull the string with the locking grub screw out but it didn't budge a bit other than the 1-2mm I've mentioned. I gave myself a stinging rope burn though...)?
|