Airsoft Canada - View Single Post

Infamous0ne · May 15th, 2011, 01:55

I installed the prometheus 6.03mm tight bore barrel, PDI hop up, prometheus hard bucking, and inner barrel stabilizers.

The only real hitch is that the piston head seems to snag on the way into the hop up chamber, the gun fires, it just seems the cylinder head is minutely out of line. I'm sure over time it would work itself to a more agreeable spot, but has anyone had the same problem? Suggestions on a fix?

Also, the barrel end I ordered is too big. Suggestions on a silencer/flash suppressor set up?

Can't wait to remount my scope and zero it in, just from the test shots I've fired she seems to be barking .28's where I want them to be with much better accuracy.

May 15th, 2011, 01:55	#10
Infamous0ne Trader rating Join Date: Apr 2011	I installed the prometheus 6.03mm tight bore barrel, PDI hop up, prometheus hard bucking, and inner barrel stabilizers. The only real hitch is that the piston head seems to snag on the way into the hop up chamber, the gun fires, it just seems the cylinder head is minutely out of line. I'm sure over time it would work itself to a more agreeable spot, but has anyone had the same problem? Suggestions on a fix? Also, the barrel end I ordered is too big. Suggestions on a silencer/flash suppressor set up? Can't wait to remount my scope and zero it in, just from the test shots I've fired she seems to be barking .28's where I want them to be with much better accuracy.