Well, I did some shooting this morning with my WE Scar and the problems of the last 2 days seem gone.
What I did is I lubed all parts very very good with silicone oil and that seem to do the trick
I have no longer a building up of bb's in the inner barrel.
So, so far so good.
The pin that holds the roller on my hammer is holding due to locktite, but its getting lose I see now...so I will have to upgrade the whole hammer with some Ra Tech parts.
I am shooting with stock hop up and a 500mm RA Tech inner barrel. The bb's: G&G .02g, 5.95
The Npas is set to highest fps (but I am not yet able to do a chrono....
Later on I will use some grease for the bolt system, cause silicon oil seems to dry up fast in those areas.
I would use "
Birchwood Casey universal gun grease" that should be sufficient for that bolt area I suppose?
But my new issue: I see splinters of bb's after I shoot.
Than I switched to the green cybergun bb's (lesser quality) and also with those I saw green splinters.
So both bb's leave splinters in my gun.
Here are some pics, splinters on the valve, at the top of the mag, in the lower receiver where the magtop is.
At the Hop up.
Is this abnormal or shouldn't I worry as long as I clean my gun after each use?
And would a cleaning kit to clean inner barrels be a good thing, like this one?
http://shop.ehobbyasia.com/accessori...etal-case.html
Or is that just a waist of money?
Thx!!!!