|
yeah, the cnc hammer is the one im getting. havnt gotten it yet though. right now im using the replacement bearing. works fine for now. I have experienced bbs building up in the barrel. although my problem for that was a little broken metal piece that moves up and down. I can't remember what it's called. I would check the o-rings on the valve. i was using regular silicone oil from canadian tire to lube the gun and later I found out that that stuff eats away rubber. So I had little gouges in the o-rings. i think gas was escaping from them because one of the o-rings was pulled out of it's lip one time. the npas fixed that.
I hope you can get yours fixed. I too want a barrel extension. I know where to get the inner barrel but I don't know where I can get an outer barrel extension. i want to improve the accuracy on it.
|