Quote:
Originally Posted by turok_t
Yes, sorry Brian, its the KM High flow valve... I got mixed up. Yeah I know my readings are low thats why I was a bit concerned. If I recall correctly, I think im using the Guarder 150%. My issue might be caused by the mag sitting too low in the grip because I can move it up by a few millimeters. Ive got the nine magazine catch so I might try the stock catch and see what happens.
Besides this solution, would you suggestion anything else?
|
If you push the mag up, does the velocity increase?
I've used the 9Ball mag catches for a while, and haven't had any problems with them. You'll have to physically inspect both the mag catch as well as the notch in the mag to check for any rounding. Any major wear will prevent proper seating of the mag, and if there is, I would recommend tossing the part.
Also check the seating between your grip and your frame. Some loose setups will allow the grip to sit too far away from the frame, and thus, the mag will sit too far away from the nozzle, causing a poor seal.
Quote:
Originally Posted by JourneyMan
Which is the sear spring?
|
I said sear PRONG on the leaf spring (the right most one). It looks like you already figured it out... you should be trying to move that one.
Secondly, check for wear on the hammer hooks. Did you mod them in any way?
I can't suggest an "angle" for the prong, as each setup is different.