[Batchokookies]

1) Classic Army MP5 SD5

2) July 2007

3) $230 USD (About $250 CAD at the time)

4) New

5) broken selector switch. Replaced it but it didn't help; it's very flimsy and can only beset on FA or safety.

6) broken bolt (never replaced it), stock cracked (replaced), wobbly front set

7) No failures. Approx 10000 rounds.

8) Modify cylinder set, Madbull 330mm 6.03 tightbore, king arms MP5 mount.

10) I know it sounds like she's flimsy, but I've put her through a lot and she works flawlessly.

----------------------------------------------------------------------------------

1) G&G M16A3 (Cansoft)

2) $320

3) January 2008

4) New

5) Came with a small type tamiya connector for a full M16 stock...

6) None.

7) About 5000

8) Madbull 10 inch open front RIS, Madbull 455mm 6.03 tightbore, Madbull 16 inch dissipator outer barrel, KA ambi mag catch, VLTOR flip up front sight, samurai flip up rear sight, G&P zombie killer silencer, KA 20mm vertical grip.

10) The polymer lower is surprisingly solid. Has an odd shreik to it when firing, it sounds like the gears are to tight. Never broken open this gearbox though.

---------------------------------------------------------------------------------------

1) KWA M226 PTP

2) July 2010

3) $180 USD ($185 CAD)

4) New.

5) Pretty weak recoil and hammer springs...

6) Sights were loose, had to cement them in place. Disassembly lever is pretty loose, but has never flipped down accidentaly.

7) No failures, about 200 rounds.

8) 2 extra mags...?

10) Well I found out the hard way that the P226 has no safety... Never crossed my mind untill after I bought it when it went off in my holster. Sights were annoying at first since Im used to stationary 92F sights but no complaints now that they're cemented in place. Frame is HEAVY DUTY steel along with the slide release, decocking lever, hammer, trigger, ect... Slide is quality steel-aluminum alloy.

I'll post my WA M92FS and KJW M9 Vertec tomorrow.