Thanks for your answers G26.
Quote:
Originally Posted by G26
|
yes
Quote:
Originally Posted by G26
PDI210% is approximately around M130 spring rate. Provided if your smithing skills are good enough and you’re running both ends with bearing, you’ll get that figure.
|
I already have a new spring - Prometheus MS135...
Quote:
Originally Posted by G26
The spec says it’s 8mm Bearing GB. Just change it to a 8mm bushing. Bearings are a no go for high springrate nor a super high ROF setup.
|
My GP gun has 7 mm bearing - confirmed, Modify modular ger set for 7mm bear. fit perfectly.
Quote:
Originally Posted by G26
Get a good brand 11.1v 15c or 20c lipo. Then get the JG M-93 Red Motor. Pair it with stock ratio gearset (reinforced, but stock ratio). Should hit the ROF you’re aiming. Get your AOE, shave the 2nd and 3rd tooth flat to avoid pre-cranking/stripped piston.
|
I have a new 9,6V battery, and i dont want Li-po. I also have a new GP M160 motor. What is AOE?
Quote:
Originally Posted by G26
Questions:
Is the “PowerUpgrade all titanium teeth piston” full metal or was it polycarb with metal tooth? Full metal (heavy) pistons aren’t good for high ROF setups.
|
Polycarb with metal tooth. I dont want too high rof anyway....