Airsoft Canada - View Single Post

kudykam · August 19th, 2009, 08:46

Hi there,
I am considering upgrade of my AEG GP-625 to fps 420-430.

I choose these parts:
PDI 210% spring
Phoenix Super Power Gear Set for Marui AEG
Guarder Infinite Torque-Up Short Type Motor
Prometheus 6.03mm inner barrel (285mm)

My question are:

Is this spring suitable for V2 gearbox?? I bought Guarder M130 (they say fo any AEG) spring but I could not fit it in by any chance, it was too long...

Is this barrel suitable for my gun, even though is designated for TM MC51, but length is ok... Design should be all the same right??

Is these gear set suitable, quality and durable for these configuration?? I have titanium teeth piston (made in Czech republic by PowerUpgrade) which is excelent btw, but my last tooth at sector gear is totally rub off.

In combination with mentioned motor I would like to get ROF about 15-20 but not to high...
I didnt find ratio fot hese gear set but hopefully could be about 21...

Is this a good motor?? I dont want to spend too much money for systema motors....

My current configuration:
M4 made by G&P upgraded by WGC
Systema piston silent head
Standard Systema teflon cylinder (no bore up)
PDi 170% spring
PowerUpgrade all titanium teeth piston
6mm steel bearings
Systema standard ratio gear set
Systema hop-up
GP M120 motor
9,6V Sanyo 3300 mAh

Thanks for any advice....

August 19th, 2009, 08:46	#1
kudykam Trader rating Join Date: Aug 2009 Location: Czech Republic - Europe	G&P M4 upgrade to fps 420 Hi there, I am considering upgrade of my AEG GP-625 to fps 420-430. I choose these parts: PDI 210% spring Phoenix Super Power Gear Set for Marui AEG Guarder Infinite Torque-Up Short Type Motor Prometheus 6.03mm inner barrel (285mm) My question are: Is this spring suitable for V2 gearbox?? I bought Guarder M130 (they say fo any AEG) spring but I could not fit it in by any chance, it was too long... Is this barrel suitable for my gun, even though is designated for TM MC51, but length is ok... Design should be all the same right?? Is these gear set suitable, quality and durable for these configuration?? I have titanium teeth piston (made in Czech republic by PowerUpgrade) which is excelent btw, but my last tooth at sector gear is totally rub off. In combination with mentioned motor I would like to get ROF about 15-20 but not to high... I didnt find ratio fot hese gear set but hopefully could be about 21... Is this a good motor?? I dont want to spend too much money for systema motors.... My current configuration: M4 made by G&P upgraded by WGC Systema piston silent head Standard Systema teflon cylinder (no bore up) PDi 170% spring PowerUpgrade all titanium teeth piston 6mm steel bearings Systema standard ratio gear set Systema hop-up GP M120 motor 9,6V Sanyo 3300 mAh Thanks for any advice.... Last edited by kudykam; August 19th, 2009 at 10:27..