KWA KM4A1 + G&G GR16 SOPMOD Tactical Stock?
 

Does anyone know if the G&G GR16 SOPMOD Tactical Stock (http://www.airsoftarmoury.co.uk/prod...roducts_id=735) is out-of-the-box compatible with a KWA KM4A1 (http://www.kwausa.com/products_m4.html)?

it's compatible. I have it on both my KWA M4 and M16

Sweet!

Thanks, plastikpyro.

Hey Plastikpyro,
 

How did you install it? I couldn't find instructions, and then G&G told me there are none.

At first glance, I'm guessing I need to unscrew the stock tube, fit the washer/nut assembly inside the new stock, remove the butt, and use a long-ass screwdriver to screw it into the receiver. Am I close?

Also, does the thumb button stick like hell on yours too?

Very easy to do. It's installed the same way the stock one was. Remove the top screw in the rear above the handle, press the switch and slide off the handle, slide the new tube on with the sling swivel mount attached to the front, insert the stop washer with the long screw and tighten. The switch is very tough to press in but theres a trick to doing it. When you press it to adjust the rear handle, don't use the lower tab but press the base right above the tab.


http://img504.imageshack.us/img504/5166/img0395eb8.jpg

Do you happen to be deadcell_2 on the KWA forums, Iv seen that exact gun before:
http://www.kwausa.com/forums/index.p...st=60&start=60
about half way down

lol yes I'm DeadCell_2 on the KWA forums.

Sweet, I got it all figured out & installed. Looks nice, though the sticky button sucks. Thanks again for all the useful info.