DIY: 3 Point Sling for $10
 

I found this on another forum, and thought I would post it up here in case anyone finds this useful.


http://matt1234.home.bresnan.net/11.JPG

Its the same type of sling that can cost as much as 40 bucks, you'll build it for under $11!

here we go

Step 1:

Gather all parts needed for the build they are:

7.5 feet of 1.5" wide nylon web
5 inch piece of 1.5" wide nylon web <-------I'm getting feedback that this piece works much better 7 inches long. To each his own, assembly is easier with the longer piece.
Two 15 inch pieces of 1" wide nylon web
Two 1.5" wide buckles
Three 1.5" wide slide locks
Two 1" wide slide locks
Tape measure
Scissors to make the 5" piece and the two 15 inchers
Lighter to seal the ends of the nylon web

All the parts needed to make the sling can be found at ACE hardware for $10.08

http://matt1234.home.bresnan.net/1.JPG

Step 2:

Slide a female buckle end onto the 1.5" web and then put a slide lock on the tail of the web itself. Paying attention to the direction of the slide and female end in the picture.

http://matt1234.home.bresnan.net/2.JPG

Step 3:

Loop the web back and through the slide lock installed in the 2nd step, make your loop 27 inches long. Paying attention to the direction of the slide and female end as before, use the picture if it helps.

http://matt1234.home.bresnan.net/3.JPG

Step 4:

Slide a 1.5" slide lock on to the web, note that you will leave an open end of the new slide lock pointing out, this will now be the "outside" of the sling. Follow picture.

http://matt1234.home.bresnan.net/4.JPG

Step 5:

Assemble this piece using the 5" long piece of 1.5" wide web and one female and one male end of 1.5" buckles. This step would be hard to describe use the picture for the details, but pay close attention to the way the web is routed and the direction of the buckles.

http://matt1234.home.bresnan.net/5.JPG

Step 6:

Slide the assembly you made in step 5 onto the sling as shown in the picture.

http://matt1234.home.bresnan.net/6.JPG

Step 7:

Assemble this mess on the open end of the sling using the last male buckle and a slide stop. I left the web loose in this picture to illustrate the way to route the sling through all the parts. Note that the tail of the web is on the outside of the sling, as described in step 4.

http://matt1234.home.bresnan.net/7.JPG

Step 8:

Tighten step 7 down to look like this, only leave 1/4-1/2 inch of web past the slide lock.

http://matt1234.home.bresnan.net/8.JPG

Step 9:

Using the two 15" pieces of 1" wide web and the two 1" wide slide locks pass them through like shown in the picture. This is where you will use the open end of the 1.5" lock left over from step 4. The 1" web passes through the outside of the male buckle installed in step 7 and 8.

http://matt1234.home.bresnan.net/9.JPG

Step 10:

Tighten everything down good, and snap all the buckles, you'll have something that looks like this when your done!

http://matt1234.home.bresnan.net/11.JPG

And here it is on an AR using GG&G sling things:

http://matt1234.home.bresnan.net/10.JPG

Its completely understandable that some don't know how to use the sling...for that reason I offer you: SLING USE

Carry in the front, pay attention to how the sling loops over the left shoulder and under the right arm.

http://matt1234.home.bresnan.net/1frontsidecarry.JPG

Carry on the right side, works well for most applications, can also be modified to sling weapon behind back by just sliding the gun further behind.

http://matt1234.home.bresnan.net/1rightsidecarry.JPG


Left side carry, excellent for transition drills, when the gun is dropped it will naturally slide to this position clearing the way for holster use on right thigh or hip

http://matt1234.home.bresnan.net/1leftsidecarry.JPG

Backpack carry, by splitting the sling straps one for left and one for right shoulder, the weapon can be carried like a backpack for a very comfortable long term carry, a hike for instance, in the sand, carrying a log of fire wood, uphill, both ways ;)

http://matt1234.home.bresnan.net/1back.JPG

Ready for use, presenting the weapon from the left side carry position, when finished drop gun and it will naturally return to left side carry, smooth!

http://matt1234.home.bresnan.net/1right.JPG

Transitioning the weapon from right to left shoulder with the sling is as easy as uncoupling the foreward-most buckle. This adds a foot or so to the sling length and makes it possible to shoot left handed while slung for a right handed shooter. Vice Versa for lefty's!

http://matt1234.home.bresnan.net/1left.JPG

Hope this helps all!

nice, I've seen this on arnies airsoft before but i find this one much more useful. i think it would be cool if this site had a do it yourself section where players can post cool tips and tricks like this to save money. anyways nice job mate.

Sorry, but the three point sling is obsolete.

It gets in the way of the bolt catch and charging handle as well as getting caught in your vest/chest rig.

Also the top carry position shown is for lazy Isrealis doing check points. Proper sling use is over your strong shoulder and under your weak arm.

too much hassle, i just use paracord lol
good job, only downside i can see are the black buckles, cant complain for 10$

Lol @ gamz! I never believed the myth that people and their dogs end up looking similar after a while until I saw that pic!

On topic, I agree with Farmboy, ever since I started using 3 points on my MP5s, over strong side and under support side is the way to go.

i think thats just fantastic gamz. i prefer the i point sling off my shoulder, but i will definatly make a back up 3pt for indoor games. thanks for posting that.