gas leaking from magazine pins?
 

I have a TM m9 mag, with hollow roll pins and I've tried lubing the fill nozzle, removing it, spraying inside, wrapping the fill nozzle in teflon tape.

I have been unable to remove the pins yet to get inside it because I cant find a pin punch that will work with the hollow roll pins. The leak is coming directly out of the pins and apparantly nowhere else. Not sure what to do even if I get it open, most people dont leak from pins because theirs arent hollow... any help would be appreciated.

You mag is most likely leaking from the seal in the baseplate. You have to take it off and inspect the o-ring, and most likely replace it.

thanks, if only I could figure out a way to get the pins out, ive tried hitting em pretty good with a hammer and proper sized allen key and I just cant seem to get em out. At this point im looking to buy an actual roll pin punch but im skeptical if even then I can get them out...

They will come out, and after do my blue automotive gasket sealer trick (thread available on here how to do it).