Cybergun Limited Custom mag issue
 

Just got this unit....with a spare mag. ONe mag works as designed...no issues. Other mag will not release gas when you press the trigger (hammer falls)....I assume it would be the button valve at the rear causing problems. How do I fix this problem? is it a lubrication or fitting issue? :banghead:

this is a Co2 mag btw.

ANy one with any advice is greatly appreciated. I looked thru the posts and only found one with similiar issues.

perhaps it has some type of block and the mag is not allowing it to fire?

Are both mags CO2?

yep..both mags are Co2.

http://www.cybergun.com/en/products/...ed-custom.htmlit is made by KWC for Cybergun....I believe the mags are similiar to sig mags for co2

this green gasket is the culprit. The pin you see in it...goes too far inside instead of stopping where it is pictured. How would I fix this?

I wonder if other valve systems would be compatible with this mag?